Symbols On The Machine; For Safe Operation - Conino Lamborghini PC 41 TL Originalbetriebsanleitung

3. Symbols on the machine

Read operator's instruction book before
operating this machine.
Wear head, eye and ear protection.
Always wear safety boots when
operating the device.
Always wear safety gloves when
operating the device.
Use the chain saw with two hands.
Warning! Danger of kickback.
Read, understand and follow all warn-
ings.
For safe operation and maintenance, symbols are carved
in relief on the machine. According to these indications,
please be careful not to make any mistake.
a) The port to refuel the „MIX GASOLINE"
Position: near the fuel cap
b) The port to refuel the chain oil
Position: near the oil cap
c) Setting the switch to the "O" position,
the engine stops immediately.
Position: rear at the left side of the
rear handl
d) Operate the choke knob.
Pull out the choke knob, close the choke;
push in the choke knob, open the choke.
Position: Air filter cover
e) Adjust the oil pump. If you turn the rod
by screwdriver follow the arrow to the
„MAX" position, the chain oil flow more,
and if you turn to the „MIN" position, less.
Position: Bottom of the power unit
f) The screw under the „H" stamp is the
High-speed adjustment screw. The screw
under the „L" stamp is the Slow-speed
adjustment screw. The screw up the „T"
stamp is the Idle adjustment screw.
Position: upper-left of the rear handle
GB | Operating Instructions

4. For safe operation

Before operate the product
5
g) Shows the directions that the chain
brake is released (white arrow) and
activated (black arrow).
Position: Front of the chain cover
Guaranteed sound power level for this equip-
ment. L
WA
Engine manual start.
1. Before using our products, please read
this manual carefully to understand the
proper use of your unit.
2. Never operate a chain saw when you
are fatigued, ill, or upset, or under the
influence of medication that may make
you drowsy, or if you are under the influ-
ence of alcohol or drugs.
3. Operate the chain saw only in well
ventilated areas. Never start or run the
engine inside a closed room or build-
ing. Exhaust fumes contain dangerous
carbon monoxide.
4. Never cut in high wind, bad weather,
when visibility is poor or in very high
or low temperatures. Always check the
tree for dead branches which could fall
during the felling operation.
5. Use safety slip-resistant footwear, snug
fitting clothing and eye, hearing and
head protection devices.
6. Always use caution when handling fuel.
Wipe up all spills and then move the
chain saw at least ten (10) feet (three
(3) m) from the fueling point before
starting the engine.
7. Eliminate all sources of sparks or flame
(ie. smoking, open flames, or work that
can cause sparks) in the areas where
fuel is mixed, poured, or stored. Do
not smoke while handling fuel or while
operating the chain saw.