Installing The Appliance - clage SMARTRONIC MCX 3 Gebrauchs- Und Montageanleitung

MCX 3..7 SMARTRONIC ®

7. Installing the appliance

5
EN
• Install the appliance with the water connectors vertically upwards for direct connection to
the sanitary tap.
• Secure the wall bracket to the wall with screws and suitable wall plugs (fig. 5).
• Place the appliance on the wall bracket and snap it into position (fig. 6). The appliance may
only be operated, if it has been placed properly into the wall bracket!
• Tap connection (fig. 7): Cold water inlet (blue) and hot water outlet (red) are marked on the
rating plate (under the rating plate cover).
• Connect the appropriate pipe or hose of the sanitary tap with the red-marked hot water
outlet. Avoid exerting any kind of mechanical pressure on the appliance, e.g. by water pipes
etc.
• After installation, carefully check all connections for leaks and rectify as necessary.
• In order to obtain an optimum water jet at low flow rates, always insert the enclosed
jet regulator into the sleeve of the tap outlet. This insert fits commercially available
sleeves with an M 22 or M 24 thread.
7
a
b
c
e
6
a. Seal
b. Strainer
c. Cold water-connection (inlet)
d. Hot water-connection (outlet)
a
e. Rating plate cover
d
24