Description Of The Appliance . En; Commissioning And Operation En - Kärcher WD 2.500 M Bedienungsanleitung

Reactive metal dust particles (such as alu-
–
minium, magnesium, zinc) in combination
with highly alkaline or acidic detergents
Undiluted, strong acids and alkalies
–
Organic solvents (such as petrol, paint
–
thinners, acetone, heating oil).
In addition, these substances may cause the
appliance materials to corrode.
Description of the Appliance
When unpacking the product, make sure that
no accessories are missing and that none of
the package contents have been damaged. If
you detect any transport damages please
contact your dealer.
Note: Please refer to page 2 for figures of the
appliance and the operation.
1 Carrying handle
2 ON/OFF switch
3 Suction hose connection
4 Container
5 Storage, power cord
6 Appliance head with clip closure
7 Storage for suction tubes and accessories
8 Mains cable with mains plug
9 Swivel casters
10 Suction hose
11 Telescopic suction pipe
12 Floor nozzle with hard surface insert
13 Crevice nozzle
14 Filter bag
15 Foam filter
8
Commissioning and operation
Always work with an inserted foam fil-
ter - during wet as well as dry vacuum
cleaning!
Attaching the Accessories
Illustration

Remove the appliance head and take ac-
cessories out of the container.
Illustration

Fit the swivel casters on the container bot-
tom. Insert filter bag if required.
Illustration

Put the appliance head onto the container
and lock it.
Illustration

Connect accessories.
Illustration
 Connect the mains plug and turn on the
appliance.
Dry vacuum cleaning
Work only with a dry foam filter!

When dry vacuuming, always install the
filter bag in addition to the foam filter.

The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced more
frequently while sucking in fine dust, sand,
etc.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!

Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).

Vacuum cleaning of hard surfaces:
Illustration
Insert the hard surface inlay into the floor nozzle.
The bristles should point towards the front.

Vacuum cleaning of carpets:
Illustration
Work without the hard surface insert.
– 2
EN