Inspection Window; Spare Parts And Accessories; Filling Device; Solenoid Valve - Kessel G Bedienungsanleitung

7.1 Inspection window

7.2 Filling device

7.3 Solenoid valve

7. Spare parts and asessories
The inspection window is used for monitoring the growth of the grease layer wit-
hout having to open the tank (odour pollution). With the tank closed, the window
can be cleaned from the inside using a hand lever. The matching screw set for
attachment to the grease separator is included in the scope of supply. The inspecti-
on window can be retrofitted. Retrofitting must be carried out by KESSEL customer
services, however!
Connection left
Connection right
The separator must be filled with water before initial operation and after disposal
before soiled water is allowed to enter.
This can be carried out
by the disposer
via connected inlet points
using a permanently installed KESSEL filling device
On site, the filling device is connected to the R1 thread connection on the inlet
pipe, in which a shut-off valve must be connected. To avoid odour pollution, the
odour trap of the siphon must always have a high enough water level. If the filling
device is retrofitted, the connection to the grease separator must be set up on
site. The KESSEL filling device with the free outlet meets the requirements of DIN
1988 DVGW and local authorities.
Connection left
Connection right
The cold and hot water inlet pipes of the filling connection can be shut off by remo-
te controlled solenoid valves instead of shut-off cocks.
Connection 1"
Connection 1
1
29
/ "
2
Art. #
917770
917771
Art. #
915 800
915 801
Art. #
916 301
916 302