Herunterladen Inhalt Inhalt Diese Seite drucken

Landing; After The Flight / Storing - Carson Skydreamer Betriebsanleitung

Glider
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22

LANDING

GB
GB
As soon as you realise that there is a decrease in
motor performance you should prepare for landing.
Ensure that you have enough reserve to correct a
wrong landing attempt and to commence a new
approach. An ideal landing should be performed as
follows:
-
Fly with a tail wind some distance parallel to
the runway.
-
If a suitable height and distance to the runway
is reached turn in a 180° curve in the direction
of the runway; now against the wind.
AFTER THE FLIGHT AND STORING
Skydreamer
When your
landed successfully you should
immediately disconnect the LiPo
battery. Then switch off the
transmitter. If another modeller would
like to use your frequency advise
them that your transmitter is now off.
You must not use your transmitter
again until you have ensured that
your frequency is not being used by
somebody else.
If you do not intend to use the radio
control unit for several weeks, you
should remove the batteries from the
transmitter.
For information relating to
the flying battery please refer to the
manufacturer's instructions and follow
the recommended advice.
The special plastic material (EPO) from which the
Skydreamer
is mainly constructed, is very
sensitive to high temperatures. Do not expose
your aeroplane to direct sunlight for a long time
and do not store it in a car which may be heated
by the sun.
18
SKYDREAMER CARSON R/C MODEL AIRCRAFT 50 050 5011
has
If you store your
make sure that no parts are jammed or twisted,
any distortion could become permanent after a
period of time and this will affect flight behaviour.
-
Straighten the model to the runway and let it
descend by reducing motor speed.
-
On approach to the landing point, lift the
elevator slightly and control speed with the
power of the motor. Insufficient speed may
cause the plane to crash.
-
Reduce the throttle a little and let the model
glide.
-
Just before touchdown, pull back the throttle
stick fully and allow the model to land.
-
If the approach is too high increase motor
speed and gain height for a new approach.
Skydreamer
at home

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis