Before Starting The Equipment; Operation - EINHELL MR 715/2 Originalbetriebsanleitung

3. Proper use
The equipment is designed exclusively for use
as an additional heater in dry, closed rooms. It is
designed to be operated only when placed on the
fl oor.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
MR 715/2
Rated voltage: ........................ 220-240 V ~ 50 Hz
Output: ...............1500 W (600 W / 900 W)
Thermostat control: ............... Infi nitely adjustable
Heating ribs: ...................................................... 7
Protection class: ................................................. I
MR 920/2
Rated voltage: ........................ 220-240 V ~ 50 Hz
Output: .............2000 W (800 W / 1200 W)
Thermostat control: ............... Infi nitely adjustable
Heating ribs: ...................................................... 9
Protection class: ................................................. I
MR 1125/2
Rated voltage: ........................ 220-240 V ~ 50 Hz
Output: ...........2500 W (1000 W / 1500 W)
Thermostat control: ............... Infi nitely adjustable
Heating ribs: .................................................... 11
Protection class: ................................................. I
Anl_MR_715_2_920_2_1125_2_SPK7.indb 13 Anl_MR_715_2_920_2_1125_2_SPK7.indb 13
GB

5. Before starting the equipment

The equipment can be used indoors in a free
standing position. Keep a minimum distance
of 50 cm between the housing and walls,
combustible materials (furniture, curtains, etc.).
The equipment may only be used completely
mounted and standing vertically on a stable
surface. It is prohibited to operate the equipment
on an instable surface (e.g. on a bed).
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate.
Read safety instructions listed under section 1.
5.1 Fitting the castors (Fig. 2 – 4)
Important! To prevent damage, place the radiator
upside down on a soft surface (for example a
carpet).
•
Place 2 castors (6) on each castor carrier (A)
and secure them with the cap nut (B).
•
Slide the fastening bar (C) under the radiator
element (A) and secure the castors carrier
with the wing nuts (D). Repeat the above on
the last space between the ribs.

6. Operation

If the equipment should topple or fall over, the
power supply will be cut off by a safety switch
integrated in the equipment. The power supply
resumes as soon as the equipment is stood
upright again.
When the equipment is used for the first time or
after a long period of rest it may emit an odor for a
short time. This is not a fault.
6.1 Function switch (Fig. 5 / Item 3):
•
Low heat output – Switch in position „I"
•
Medium heat output – Switch in position „II"
•
High heat output – Switch in position „I+II"
The possible output levels are listed in the
technical data in point 4.
Note:
For safety reasons, the heater will switch off at a
certain heating rib temperature in order to prevent
overheating of the heating ribs at maximum heat
- 13 -
09.01.2017 14:28:58 09.01.2017 14:28:58