Facom 1003A.E Bedienungsanleitung Seite 15

7. Maintenance
Note:
Only use genuine FACOM consumables and spare parts in order to
ensure reliable function and to maintain the unit's warranty.
• Make sure that the tip is always tinned.
• If required, wipe the tip on a damp sponge prior to desoldering in
order to remove used solder and fl ux residue.
To obtain good electrical and thermal conductivity, occasionally remove
the soldering tip and clean the heating element shaft with a brass
brush.
• Make certain that the effectiveness of the ventilation holes is not
impaired by a build-up of dust.
NU-1003A.E_0208.indd 15 NU-1003A.E_0208.indd 15
1002.P1
1002.P2
1002.P3
1003A.80E
661618
Sn40Pb60
Ø 1 mm
661626
Sn60Pb40
Ø 1 mm
20/03/2008 14:03:20 20/03/2008 14:03:20