Introduction; Security Advice - Auerswald Analog/ISDN Converter Installations- Und Bedienungshandbuch

32

Introduction

Introduction Dear customers!
This manual here describes the use, installation
and configuration of the Analog/ISDN Converter in
detail. Before starting with the installation, please
read the following security advice.
Pay attention to the following general se-
curity advice:
- Read the user manual and keep it for reference.
- The device described in this manual is made for
the indicated use only. If you are not sure about
the intended purpose of the product, please
contact your dealer.
- Pay attention to the limitation stated in the tech-
nical data. Exceeding these limitations (even if
for a short time) may cause considerable dam-
age.
- Pay attention to the relevant standards when
using 230 Volt power supply and units operating
on the power supply.
- Repairs should only be done by an expert. Con-
tact your authorized dealer or the manufacturer if
necessary.
Improper use or replacement of the
wall-mounted power supply can result
in a dangerous electric shock or may
damage or destroy the device:
- Use only the enclosed wall-mounted power
supply (type number VD100055H)
- Make sure the plug is inserted securely into
the wall mains outlet. Loose plugs or damaged
outlets are a fire hazard.
- Do not pull on the cable of the wall-mounted
power supply. Carefully pull the wall-mounted
power supply out of the socket if you want to
switch off device power.
- If the wall-mounted power supply becomes
damaged: Cut off the mains power in the
house first before pulling the plug of the wall-
mounted power supply.
Touching the voltage carrying conduc-
tors may result in a dangerous electric
shock.
1) Starting with Hardware revision 2 (Rev. 2) the wall-mounted
power supply DV-10W3UP will be used instead of VD100055H.
this manual.

Security Advice

- Therefore disconnect the device from the 230
Volt socket and from the network provider
connection before opening the case.
- Do not remove the printed circuit board out of the
case.
- Use the unit with a closed case only.
- Use the unit mounted on the wall only.
- When using tools at live circuits, pay attention to
sufficient isolation.
- Pay attention when selecting the installation
location and when cleaning the case to prevent
liquids from entering the case.
the device itself may be hazardous to life and limb.
- The mains cables of the electric devices and the
connection cables must be checked regularly for
damage, and if damage is present, the cables
1) must be replaced.
.
- Replace damaged components (e.g. compo-
nents of the case) immediately.
- Use original components only. Otherwise the
device may be damaged or security and EMC
regulations may be violated.
- Therefore do not install the device during a
thunderstorm. Also do not work on cable con-
nections during a thunderstorm.
- Do not connect the PC permanently to the
USB connection but only in case of configura-
tion.
Pay attention to the information in the ad-
ditional brochure "Guarantee declara-
tion, information service" in addition to
Liquids entering the case may cause a
dangerous electric shock or may dam-
age or destroy the device.
Touching a defective connection ca-
ble may result in a dangerous electric
shock. Also any damage to the case and
Surge voltages like generated by a thun-
derstorm, may result in a dangerous
electric shock.