Select And Start A Washing Programme; Unloading The Dishwasher - Progress PVS1530 Benutzerinformation

76 progress
washing programme without loading any
dishes.

Select and start a washing programme

Select the washing programme with
the door slightly opened. The start of
the programme will occur only after
the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the programme selection/RESET-
button until the light corresponding to the
required washing programme comes on
(see "Washing programmes" chart).
Close the dishwasher door, the pro-
gramme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Cancel a washing programme in
progress
• Open the dishwasher door; press the pro-
gramme selection/RESET button for about
3 seconds, until the light of the running

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless
3. Adjust the water hardness setting ac-
cording to the hardness of the water in
your area.
4. Adjust the rinse aid dosage.
programme goes off and the End indicator
light flashes. The washing programme has
been cancelled and the appliance is now
in setting mode.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
Interrupt a washing programme in
progress
Open the dishwasher door; the programme
will stop. Close the door; the programme will
start from the point at which it was interrup-
ted.
End of the washing programme
• The dishwasher will automatically stop and
an audible signal informs you of the end of
the washing programme.
• Open the dishwasher door.
• The End of programme indicator light is
on.
• The indicator light of the programme just
ended remains on.
1. Switch off the dishwasher by pressing the
On/Off button.
2. Leave the dishwasher door ajar and wait
a few minutes before removing the
dishes; in this way they will be cooler and
the drying will be improved.
steel will eventually become cooler than
the dishes.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.