Proper Use; Safety Instructions - Zipper ZI-KGS210 Bedienungsanleitung

8. Start switch
9. Saw blade
safety lock
10. Cover cap
carbon brush
11. Saw blade
protection
pivotable
12. Lock bolt saw
aggregate
13. Laser with
battery
compartment
14. Work piece
support
15. Latch lever
16. Lock knob
angle
17. Angle indication
18. Work piece
fence
Technical details as well as design may
change because of product development.
That s why changes are reserved.
8 SAFETY
8.1

Proper use

The ZIPPER mitre saw ZI-KGS210 may be
operated for the following works if you
consider the
maintenance instructions.
· Mitre cuts into wood.
· Only when worked like required at the
section operation.
· Operation only by one person.
· Operation only with fixed work piece.
· Operation only with mounted saw blade
cover.
· When firewood can t be fixed well you
mustn t cut it.
· Operation is only allowed for tempera-
tures between +5 and +40°C. The air
humidity at +40°C must not be higher
than 60%.
· You are only allowed to operate the
machine at a height above the sea level
of 1000m.
If you do not operate the machine like
stated in this manual all the guarantee
Lets the machine start.
Prevents the saw arm from
unintentional lowering.
Open with a screw driver
Change it immediately when
damaged!
Can lock the saw arm at the
lowest and the highest
position.
For marking the cutting line
on the work piece.
For longer work pieces
telescopic
Push it down for free
swivelling.
For locking the saw arm at
each angle.
Shows the angle
Slidable to the outside,
adjustable
safety-, operation-
and compensation claims towards ZIPPER
GmbH will be terminated.
The same is true for self-made changes
and manipulations on the machine.
8.2
ZIPPER MASCHINEN cannot be held re-
sponsible for any injuries or damages if
there was performed manipulation or ad-
justments to the machine.
If you give the machine to a third person
you also have to give this manual to that
person.
and

Safety instructions

Do not operate the machine at
insufficient lighting conditions.
Do not operate the machine
when you are tired, when your
concentration is impaired, and/
or under the influence of drugs,
medication or alcohol.
The machine shall be used only
by trained persons.
Non authorized
especially children,
kept away from the work area.
Always be focused
working, take care to maintain a
safe posture at every time.
Do not work on slippery ground.
Slipping/ stumbling/
down are a frequent cause of
severe injuries.
Do not wear loose clothing,
long hair openly
jewellery like necklaces
when operating the machine
They might be
rotating parts and cause serious
injuries.
Use proper safety clothing and
devices when operating
machine (safety goggles,
protectors, safety shoes
maintenance work you also have
to wear safety gloves.
EN
persons,
shall be
when
falling
or loose
etc.
catched by
the
ear
)! For