Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Operation
4.1. Setting the Output Voltage of CH1 and CH2
1.
Connect the power supply to the power source.
2.
Press the POWER SWITCH [1] to turn on the power supply.
3.
Press AUTO CURRENT CUT OFF PROTECTION KEY [2] to activate output and the OUTPUT
INDICATOR [3] will on.
4.
To set CH1, use the CH1 VOLTAGE TUNE KNOB [6] to adjust CH1 voltage to give a desired
output voltage.
5.
Connect the circuit to the TERMINALS [21,22]
6.
When the CH1 CV/CC INDICATOR [5] is in red color, adjust the CH1 CURRENT TUNE KNOB [4]
to give a suitable current.
7.
To set CH2 voltage, repeat the above steps use CH2 VOLTAGE TUNE KNOB [11], short MAIN
TERMINAL [18,19] and CH2 CV/CC INDICATOR [12] instead.
Remarks:
If CH2 cannot be adjusted, check the TRACKING MODE SELECTION KEY [14, 15] is not
pressed.
If want to preset a desired current output before connecting to the circuit, read Section 4.2
first.
Caution:
Make sure the INPUT VOLTAGE SELECTOR [26] set to a correct position Otherwise; it will
damage the power supply.
Do not short the MAIN TERMINALS over 1 minute; it will damage the power supply.
-16-
Werbung
Inhaltsverzeichnis
