Operation - PeakTech 1645 Bedienungsanleitung

5. Operation

NOTICES:
Read and understand all warning and precaution
statements listed in the safety section of this operation
manual prior to using this meter. Set the function select
switch to the OFF position when the meter is not in use.
5.1. AC Current Measurements
1. Set the function switch to the 200 A range.
2. Press the jaw trigger and clamp around, fully enclosing
a single conductor. Do not allow a gap between the two
halves of the jaw. Refer to the diagram below for the
correct way to enclose a single conductor.
3. Read the ACA value on the LCD.
-28-