Maintenance And Cleaning - Electrolux EOG 21300 Gebrauchsanleitung

6 electrolux
• Always stand back from the oven
when opening the oven door during
cooking or at the end of it to allow
any build up of steam or heat to
release.
• Do not block any of the oven vents. Never
line any part of the oven with aluminium
foil.
• Do not allow heatproof cooking material,
e.g. roasting bags, to come into contact
with oven elements.
• Never place plastic or any other material
which may melt in or on the oven.
• Do not place sealed cans or aerosols
inside the oven. They may explode if they
are heated.
• Do not hang towels, dishcloths or clothes
from the oven or its handle.
• Do not use this oven if it is in contact with
water and never operate it with wet
hands.
• Take great care when heating fats and
oils as they will ignite if they become too
hot.
• Always use oven gloves to remove and
replace food in the oven.
• Ensure that all control knobs are in the
OFF position when not in use.
• Do not leave cookware containing
foodstuffs, e.g. fat or oil in or on the oven
in case it is inadvertently switched ON.
• When using other electrical appliances,
ensure the cable does not come into
contact with the hot surfaces of the oven.
• Do not use harsh abrasive cleaners or
sharp metal scraper to clean the oven
door glass since they can scratch the
surface, which may result in shattering of
the glass.

Maintenance and Cleaning

• Only clean this oven in accordance with
the instructions.
• This appliance cannot be cleaned with
steam or with a steam cleaning machine.
•
Do not use abrasive cleaners or sharp
metal scrapers. These can scratch the
glass in the oven door, which may result
in the shattering of the glass.
• The oven should be kept clean at all
times. A build-up of fats or other foodstuffs
could result in a fire, especially in the grill
pan.
• Always allow the oven to cool down and
switch off the electrical supply before
carrying out any cleaning or maintenance
work.
Service
• This oven should only be repaired or
serviced by an authorised Service Engineer
and only genuine approved spare parts
should be used.
• The manufacturer disclaims any
responsibility should these safety
measures not be carried out.