Scheppach 7906100720 Originalbetriebsanleitung Seite 19

2. Fill the desired amount of blasting material (12)
into the blasting material container (4).
3. Make sure that you do not exceed the maximum
container capacity of 850 ml.
4. Then close the screw cap (5) of the blasting ma-
terial container (4) again by turning it clockwise.
9.2.1 Note on the particle size of the blasting ma-
terial
• The larger/coarser the particle size of the blasting
material used, the coarser the dirt it removes.
• The material supplied is rather fine and is suitable
for removing paint and rust film, for example. The
fine material also causes less damage to the sur-
faces, which is why a selection can also be made.
• For coarse rust, for example, use coarser-grained
blasting material. Please also note the information
on maximum particle size.
9.3 Selecting and fitting attachments (Fig. 1, 2)
1. First select a suitable attachment (8, 9, 10, 11) for
your purposes.
2. Attach the selected attachment firmly to the jet
nozzle (7) and ensure that no air can escape from
the side.
9.4 Using the compressed air sandblasting gun
(Fig. 1, 3)
•
Prepare the workpiece to be irradiated carefully.
Clean it if necessary. Dust and grease deposits im-
pair the result considerably.
•
Carefully cover or tape everything that is not to be
irradiated.
•
The distance between the attachment and the
surface to be treated plays an important role and
should be kept as small as possible so that the blas-
ting material (12) can be collected by the collection
bag (6).
•
The closer you get to your workpiece with the de-
vice, the smaller the beam pattern on it and vice
versa.
•
If necessary, carry out a test run beforehand on a
workpiece that is no longer required in order to find
the correct distance and prevent excessive abrasion
on your workpiece.
9.5 Switching on (Fig. 1)
1. Guide the compressed air sandblasting gun up to
the surface to be treated.
2. Press the trigger lever (3) to start up the com-
pressed air sandblasting gun.
9.6 Switching off (Fig. 1)
1. Release the trigger lever (3) to switch off com-
pressed air sandblasting gun.
2. Disconnect the product from the compressed air
source after work.
NOTE
First disconnect the hose from the compressed air
source and only then remove the supply hose from the
device. This prevents the supply hose from swirling
around uncontrollably.
9.7 Emptying the collecting bag for sandblasting
media (Fig. 1)
NOTE
Do not reuse excess sandblasting material from the
collection bag before it has been cleaned.
1. Remove the collection bag (6) from the outlet (7a).
2. Empty and clean the collecting bag (6).
3. Fasten the collection bag (6) to the outlet (7a)
again.
10. Cleaning
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product.
11. Maintenance
The interior of the product has no further internal parts
that require maintenance.
12. Storage
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store product in the original packaging. Cover the
product to protect it from dust or moisture. Store the
operating manual with the product.
www.scheppach.com GB | 19