Unpacking; Technical Data; General Safety Instructions - Scheppach 7906100720 Originalbetriebsanleitung

5. Unpacking

m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
• Open the packaging and carefully remove the product.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.

6. Technical data

Max. working pressure
Air consumption
Dirty water
Volumetric flow rate
Required air quality
Subject to technical changes!
Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Information about noise level measured in accord-
ance with EN 14462
Noise data
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
WA/pA
Vibration parameters
Vibration value per EN 14463-1
Vibration a
m WARNING
The vibration level specified in this instruction has
been measured based on a measurement procedure
standardised in EN 14463-1 and can be used for unit
comparison. The specified vibration emission value
can also be used for an initial estimation of the expo-
sure. The vibration level will vary depending on the
use of the tool and may in some cases be higher than
the value specified in these instructions. The vibration
load could be underestimated if the tool is regularly
used in such a way.
NOTE
For an accurate estimation of the vibration exposure
during a given working period, the times when the de-
vice is switched off or running but not actually in use
should also be taken into account. This can signifi-
cantly reduce the vibration load over the entire wor-
king period.
7.
m WARNING - Read all safety information, in-
3.5 bar
structions, illustrations and technical data for this
product.
113 l/min
Failure to follow all instructions listed below may result
850 ml
in electric shock, fire and/or serious injury.
200 g/min
Save all warnings and instructions for future reference.
cleaned, free of oil
Workplace safety
• Keep your work area clean and well-lit. Disorgan-
• Do not work with the device in an explosive environ-
• Keep children and other people away while using the
Specific safety instructions for compressed air
103 dB
sandblasters
92 dB
• Check the device for any damage before putting it
3 dB
www.scheppach.com
h

General safety instructions

ised and unlit work areas can result in accidents.
ment where flammable liquids, gases or dusts may
be located. The tool can create sparks which may
ignite the dust or vapours.
tool. Distractions may cause you to lose control of
the device.
into operation. If the device has any defects, it must
not be put into operation under any circumstances.
<2,5 m/s²
GB | 17