Unpacking; Start Up - Scheppach 7906100721 Original Bedienungsanleitung

Information about noise level measured in accord-
ance with EN 1953
Noise data
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
wa/pA

8. Unpacking

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the device by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and spare
parts use only original parts. Spare parts can be ob-
tained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m WARNING!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
9.

Start up

m Attention!
Always make sure the device is fully assembled
before commissioning!
HVLP properties
This device has an HVLP (High Volume Low Pressure)
system. It ensures increased (paint) material applica-
tion with lower consumption.
Important: Do not exceed the maximum working pres-
sure of 3 bar.
Connect device
•
The product may only be operated with cleaned,
condensate and oil-free compressed air and must
not exceed the maximum working pressure of 3 bar
at the device.
100.3 dB
•
To enable you to regulate the air pressure, the com-
90.8 dB
pressed air source must be equipped with a (filter)
pressure reducer.
3 dB
You need a flexible compressed air hose with quick
coupling and a corresponding compressed air source
to operate this device.
Observe the operating and safety instructions of the
compressed air source and special instructions for col-
our preparation.
Note: Make sure that the working pressure is correct.
Excessive working pressure leads to strong fine dis-
tribution and entails too rapid liquid evaporation. The
surfaces become rough and develop poor adhesive
properties. If, on the other hand, the working pres-
sure is too low, the paint material will not be sufficient-
ly atomised. Wavy surfaces and drop formation are
the result.
•
Connect the compressed air hose with quick cou-
pling to the compressed air connection (6) of the
device. The locking mechanism is automatic.
•
Set the working pressure to 3 bar on the filter pres-
sure reducer of the compressed air source.
Prepare spray area
•
Thoroughly cover a generous area around the area
to be sprayed. Any uncovered areas or surfaces
may otherwise become contaminated.
•
Make sure that the spray surface is clean, dry and
free of grease.
•
Roughen smooth surfaces and then remove the
sanding dust.
Switching the device on / off
Working instructions:
•
Insert the filter into the gun (see Fig. C).
•
Open the aspiration (1) while it is working.
•
When diluting, make sure that the spray material
and dilution match. If the wrong thinner is used,
lumps may form and as a result the gun may clog.
•
Screw the flow cup (3) clockwise onto the gun.
•
Fill the spray material into the flow cup (3) and
screw the cover (2) tight.
•
Always keep the paint spray gun at the same dis-
tance from the object. The ideal spraying distance
is approx. 15 cm.
www.scheppach.com GB | 19