Care And Maintenance; Main Unit; Filter Cleaning; Dust Sensor Odor Sensor - Sharp FU-55SE Bedienungsanleitung

CARE AND MAINTENANCE

(To maintain the best performance of this product, please clean the unit periodically.)
When cleaning, be sure to remove the power plug from the wall outlet. In addition, never handle
the power plug with wet hands.
Electrical shock and/or bodily injury may occur as a result.

MAIN UNIT

For soiling on the main unit and
the installed floor / table surface,
clean as early as possible. Stub-
born dirt may be hard to remove.
Dry wipe with a soft cloth
For stubborn dirt, wipe with a
soft cloth dampened with water
or warm water of 40°C or less.
Do not use volatile fluids
Benzene, paint thinner, polish-
ing powder, etc., may damage
the unit surface.
Do not use detergents
Detergent ingredients may dam-
age the unit surface.
Keep the unit dry
Never apply water on the unit.
FILTER
CLEANING
Clean the top surface of the pre-
filter lightly with a vacuum
cleaner.
Pre-filter
NOTE
• The HEPA filter is damaged
easily. Do not bring it into di-
rect contact with the nozzle of
a vacuum cleaner.
Also make sure never to wash
it with water.
• The HEPA filter and Active
carbon filter do not need clean-
ing.
FU-55SE_Eng.6.5
DUST SENSOR
ODOR SENSOR
The care cycles of ODOR SENSOR and DUST
SENSOR are once three months.
The sensitivity of the sensors will become unstable
if the odor or dust sensor is dirty or blocked. Please
clean these parts as follows.
DUST SENSOR
1
2
3
CAUTION
• Do not forget to reinstall the sensor cover before
restarting the unit.
• Do not insert foreign object (toothpick, etc,)
into the filter. This may result in damage or mal-
functioning of the unit.
ODOR SENSOR
Remove dust from the sur-
face of the sensor opening
with a vacuum cleaner.
E-13
13
Remove the front
panel and detach the
sensor filter
• Detach the sensor filter
while pulling the tab on
the sensor cover.
Remove dust from
sensor filter.
• Detach the sensor fil-
ter, and tap it lightly
with your hand to re-
move the dust.
If it is very dirty, wash it
with water and then al-
low it to dry thoroughly.
Insert the sensor fil-
ter into the cover, in-
stall it in the main
unit and attach the
front panel.
• The sensor filter can be
inserted either way
round.
Sensor
opening
03.7.17, 8:53 AM
Sensor cover
Sensor filter
Sensor cover