Remote Control Operation - Sharp FU-55SE Bedienungsanleitung

REMOTE CONTROL OPERATION

• To start operation, press the POWER ON/OFF button.
A short beep will sound and operation will start in AUTO opera-
tion (fan level).
AUTO cluster ion mode is selected for cluster ion operation.
• To stop operation, press the POWER ON/OFF button again.
A long beep will sound and operation will stop.
POWER ON/OFF button
Used to start AUTO opera-
tion (short beep) and stop op-
eration (long beep).
AUTO (fan level) button
The fan level switches auto-
matically depending on the
amount of pollution in the air.
MANUAL (fan level) button
The fan level can be switched
between Silent, Medium,
High and Max.
DISPLAY ON/OFF button
Switches the Cluster ion
lamp and CLEAN-SIGN
lamp either ON or OFF.
• The cluster ion lamp is
turned on for about 3 sec-
onds by pressing the clus-
ter ion select button (ex-
cluding the OFF button)
during "DISPLAY OFF"
mode.
AUTO cluster ion button
The unit will switch between Clean mode and
Ion control mode automatically depending on
the amount of pollution in the air detected by
the dust and odor sensors.
'Clean mode' operation is carried out for about
1 minute when operation first starts.
Ion control button
The unit will constantly operate in Ion control
mode.
Ion balance is maintained in the room by in-
creasing the ratio of Negative cluster ions.
(Cluster ion lamp on (green))
If the room smells especially moldy, operate the unit in Clean mode.
FU-55SE_Eng.6.5
Plasmacluster
AUTO
Cluster ion select button
E-11
11
Operations available
with remote control
• AUTO operation (fan level)
• MANUAL operation (fan level)
• Pollen mode operation
• OFF timer setting
• DISPLAY ON/OFF
• Cluster ion mode selection
• AUTO cluster ion mode
• Clean mode
• Ion control mode
• Cluster ion OFF mode
Transmitter
Filter reset button
Press this button after replacing
RESET
the filters.
Pollen mode operation button
The unit operates effectively
when you suspect there is pol-
len in the air. See Page E-10
OFF timer button
Used to set the OFF timer.
The set time switches every time
the button is pressed as shown
below.
OFF
1 hour
Cancel
• The remaining time is indicated
by the lamp as time passes.
• The unit will stop operation
when the set time is up.
Clean button
The unit will constantly operate in
Clean mode. Clean mode is effec-
tive for reducing some airborne
mold. (Cluster ion lamp on (blue))
OFF button
The generation of ions is stopped
and the cluster ion lamp is turned
off.
03.7.17, 8:53 AM
4 hours
8 hours