Scheppach LBH3000E Originalbetriebsanleitung Seite 32

9.2 Fitting the collection bag (Fig. 5)
The collection bag (8) is only required when operating
as a leaf vacuum. Before starting work, check that the
zip of the collection bag (8) is properly closed.
1. Place the collection bag inlet with locking device
(8b) on the ejection opening (14). Make sure that
the collection bag inlet with locking device (8b) is
properly engaged.
2. Hang the collection bag eye at the rear (8a) in the
hook at the rear (12a).
3. Hook the front collection bag eye (8c) into the
front hook (9a).
9.3 Remove the collection bag (8)
1. Remove the front collection bag eye (8c) from the
front hook (9a).
2. Actuate the two locking devices on the collection
bag inlet (8b).
3. Pull the collection bag inlet with locking device
(8b) off the ejection opening (14).
4. Remove the rear collection bag eye (8a) from the
rear hook (12a).
9.4 Fitting the carrying strap (Fig. 1, 2)
1. Open the carabiner hook (13a) of the carrying
strap (13).
2. Clip the carabiner hook (13a) into the fastening
eye of the carrying strap (2).
3. Adjust the length of the carrying strap (13) to suit.
Note
Never wear the carrying strap (13) diagonally across
your shoulder and chest, but only on one shoulder, this
allows you to quickly remove the product from your
body in the event of danger. Open the buckle to be
able to open the catch (13) quickly in the event of an
accident.
10. Commissioning
m Attention!
Always make sure the product is fully assembled
before commissioning!
10.1 Cable strain relief (Fig. 6)
Warning!
Ensure that the on/off switch is in position "0".
32 | GB
1. For operation you need an extension cable (not
included in the scope of delivery) for outdoor use
(max. 50 m, 2.5 mm
with the extension cable.
2. Pass the loop through the cable strain relief (6)
and hang it in the hook of the cable strain relief
(6).
3. Insert the mains plug into the corresponding end
of the extension cable.
10.2 Select operating mode (Fig. 1)
The operating mode can be selected using the mode
selector lever (7):
Use as a leaf vacuum.
Use as a leaf blower.
m Attention!
Changing the operating mode while the product is
switched on may result in injury and damage to the
product.
10.3 Start,
1. Connect the extension cable to a suitable energy
source.
2. When using as a leaf vacuum, make sure that the
collection bag (8) is properly fitted.
3. Move the on/off switch (4) into the "I" position.
10.4 Switching off
1. Move the on/off switch (4) into the "0" position.
11. Operation
11.1 Set the engine speed
The motor speed can be adjusted using the speed con-
trol (3). To do this, turn the speed control (3) and select
the appropriate level. Levels 1-6 can be selected.
The engine speed should be adapted to the type of ma-
terial to be removed:
• Use a low motor speed for light material on the lawn.
• Use a moderate motor speed to move grass and
light leaves on asphalt or solid ground.
• Use a high speed for larger garden waste.
www.scheppach.com
cross-section). Form a loop
2