Scheppach HBS400 Originalbetriebsanleitung Seite 25

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Product description (Fig. A - AC)
1. Housing door
2. Door lock
3. Band saw blade guard
4. Saw band guide
5. Parallel stop
6. Table width extension
7. Saw table
8. Clamping lever
9. Main frame
10. On/off switch
11. Tensioning screw for saw band tension
12. Tensioning screw for belt tension
13. Locking knob for the saw band guard
14. Mitre gauge (not shown/optional)
15. Machine stand
3. Scope of delivery
• Band saw (machine frame)
• Saw table
• Retainer plate
• Rail with scale
• Push stick
• Rip fence
• Allen key
• Screwdriver
• Open-ended spanner (2x)
• Frame legs (4x) (a)
• Cross member, top (2x) (d)
• Longitudinal member, top (2x) (e)
• Cross member, bottom (2x) (b)
• Longitudinal member, bottom (2x) (c)
• Rubber foot (4x) (f)
• Wheel set (g)
• Table width extension with guide rail for rip fence
• Fixing material
• Original Operating Manual
4. Proper use
The band saw is used for the longitudinal and transverse
cutting of timbers or wood-like workpieces. Round ma-
terials may only be cut using suitable holding devices.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
Only saw bands that are suitable for the machine may
be used. An element of the intended use is also the
observance of the safety instructions, as well as the
assembly instructions and operating information in the
operating manual.
Persons who operate and maintain the machine must
be familiar with the manual and must be informed about
potential dangers.
www.scheppach.com GB | 25