Assembly; To Assembly The Protective Cover; To Disassemble The Protective Cover; To Attach The Guard For The Cutting Disc - Meec Tools 033069 Bedienungsanleitung

EN
● In order to decrease the danger of serious or fatal injuries, it is recommended that
individuals who wear medical implants should consult their doctor and the
manufacturer of the implant before operating the machine.
SV
3

Assembly

NO
WARNING! Stop the product and pull out the plug from the power source before
you attach the guard.
DA
3.1

To assembly the protective cover

Figure 2
PL
1
Move the protective cover (A) onto the blade guard (B).
DE
2
Push the parts together and make sure that the plastic clip locks into position at
the end.
FI

3.2 To disassemble the protective cover

Figure 2
FR
1
Push the plastic clip a small distance forward.
2
NL
Pull off the protective cover (A) from the blade guard (B).

3.3 To attach the guard for the cutting disc

WARNING! The guard must be installed when you use the product.
WARNING! Make sure that you use the correct disc for the operation. Cutting
discs are much thinner than sanding discs. Incorrect use of the product can cause
rupture or breakage.
● The guard with the combination of protective cover (A) and disc guard (B) is used
with the cutting disc. This guard is used for protection against flying fragments in
case of disc breakage.
● The disc guard (B) is used with the sanding disc.
12