Scheppach MTE380 Originalbetriebsanleitung Seite 32

17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Engine does not start
Engine power diminishes
The motor hoe is difficult
to control during operation
(machine jumps or crawls)
Motor runs, cutting roller
does not rotate
32 | GB
Possible cause
• No power in the mains
• Cable defective
• Switch plug combination
defective
• Connections on the motor or
capacitor loosened
• Cutting roller blocked
• Ground too hard
• Carbon brushes worn out
• Blade heavily worn
• Blade heavily worn
• The base is too hard
• Gearbox defective
www.scheppach.com
Remedy
• Check the lead and fuse
• Have checked by customer service
workshop
• Have checked by customer service
workshop
• Have checked by customer service
workshop
• If necessary, change the working depth,
clean the housing so that the cutting roller
runs freely
• Correct the working depth
• Have checked by customer service
workshop
• Have blades replaced
• Replace blade
• Set the throttle to a lower speed
• Have checked by customer service
workshop