Scheppach MTE380 Originalbetriebsanleitung Seite 24

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Product description (Fig. 1 - 10)
1. Handle
2. Mains cable
3. Upright
4. Lower bar
5. Screw
6. Machine body
7. Cutting roller
24 | GB
8. Coach bolt
9. Wing nut
10. Cable guide
11. Release button
12. On/off switch
3. Scope of delivery (Fig. 2)
• 1x Handle (1)
• 1x upright (3)
• 2x lower bar (4)
• 1x Machine body (6)
• 4x carriage bolts (8)
• 4x wing nuts (9)
• 2x cable guide (10)
• 1x operating manual
4. Proper use
The product is suitable for digging over soil (e.g. gar-
den beds). Be sure to observe the restrictions in the
safety instructions.
The user instructions also contain the operating, main-
tenance and servicing conditions.
For safety reasons, the product must not be used as
a drive unit for other working tools and tool sets of
any type.
The product may only be used in the intended manner.
Any use beyond this is improper.
The user/operator, not the manufacturer, is responsi-
ble for damages or injuries of any type resulting from
this.
Please note that our products were not designed with
the intention of use for commercial or industrial pur-
poses. We assume no guarantee if the product is used
in commercial or industrial applications, or for equiv-
alent work.
5. Safety instructions
GENERAL SAFETY INSTRUCTIONS
WARNING! Read the entire manual carefully. Famil-
iarise yourself with the control and proper use of the
device. Failure to follow the instructions may result
in electric shock, fire and/or serious injury. The term
"power tool" used in the warnings below describes your
device. The device can be either a cable-operated or a
battery-operated (wireless) device.
www.scheppach.com