Maintenance And Care - AL-KO Snow Line 55E Betriebsanleitung

en
Stopping operation
1. Letting safeguarding hangers off.
The snow blower stops moving.
Unclogging the snow discharge chute
If snow does not discharge properly, the augers
or the discharge chute may be clogged with snow
or ice.
1. Release the safety bar. (9-1, 1-2)
Snow blower stops
2. Switch off the engine.
3. Disconnect the spark plug connector.
4. Carefully remove the snow from the discharge
chute and auger using the useful cleaning tool
(1-7, 1-8)
If snow still does not discharge properly, contact
a qualified workshop.

MAINTENANCE AND CARE

CAUTION!
risk of injury!
Before performing any maintenance or
service, always switch off the engine and
disconnect the spark plug connector.
The engine may coast down. After swit-
ching off, make sure that the engine is at
a standstill.
Clean the machine after every use. Be espe-
cially sure to remove residual de-icing salt.
Do not hose down the unit with water! Water
penetration may cause malfunctions (ignition
system, carburettor).
Replace the silencer if defective.
Follow the maintenance schedule.
Follow the instructions in the engine manual.
Maintenance schedule
After the first 5 hours of operation
Change the engine oil (see engine manual).
Before each use
Check the oil level (see engine manual).
Check the shear pins.
Check machine for damage.
After every use
Sputum shaft, snail, handles and cases
clean.
20
As required
Checking clearing up plate (9-4), exchanging
abgenutze clearing up plate.
Every three months
Lubricate the snow discharge chute ring with
spray oil
1 x per season
Letting check and service equipment in a sub-
ject workshop.
Annually
Replace spark plug (see engine manual).
Clean the machine
CAUTION!
Do not hose down the machine with wa-
ter! Water could get into the switch-plug
combination and the electric motor and
damage these.
1. Switch off the machine on solid, level and ho-
rizontal ground.
2. Remove residual road salt and dirt.
Always follow the instructions in the en-
gine operating manual provided.
If the wheel drive no longer engages when the en-
gine is running, the control cable must be adjus-
ted.
CAUTION!
risk of injury!
Switch off the engine before adjus-
ting the control cable.
If the wheel drive mechanism cannot
be disengaged, switch off the en-
gine. Do not attempt repair; contact
a qualified workshop.
Drawing protection of the bowden cable fea-
ther up.
Closest to Sicherungstift into this higher put
regulation element in (X).
Stretching protection of the bowden cable
feather to down.
Check the adjustment by starting the engine
and engaging the wheel drive.
If the wheel drive still does not engage and
disengage properly, have the machine repai-
red by a qualified workshop.
Operation
440829_a