Maintenance And Care - AL-KO Snow Line 700E Betriebsanleitung

Snow Line 700E, 760TE

Maintenance and care

Danger - risk of injury!
▪ Before performing any maintenance or service,
always switch off the engine and disconnect the
spark plug connector.
▪ The engine may coast down. After switching off,
make sure that the engine is at a standstill.
„ Clean the machine after every use. Be especially
sure to remove residual de-icing salt.
„ Do not hose down the unit with water!
Water penetration may cause malfunctions (ignition
system, carburettor).
„ Replace the silencer if defective.
„ Follow the maintenance schedule.
„ Follow the instructions in the engine manual.
Maintenance schedule
Before each use
Check the oil level (see engine manual).
„
Check the shear pins.
„
Check machine for damage.
„
After the first 5 hours of operation
Change the engine oil (see engine manual).
„
Every three months
Check the tyre pressure.
„
Oil the ring of the snow discharge with
„
spray oil ( 6).
Annually
Replace spark plug (see engine manual).
„
Lubricate auger.
„
Lubricating the auger
Using a grease gun, inject 2 to 3 shots of universal
grease into the grease nipple (
474911_c
31).
Maintaining the wheel drive
Adjusting the control cable
If the wheel drive no longer engages when the en-
gine is running, the control cable must be adjusted.
Caution!
▪ Switch off the engine before adjusting the
control cable.
▪ If the wheel drive mechanism cannot be
disengaged, switch off the engine. Do not
attempt repair; contact a qualified workshop.
1. Loosen lock nut (
2. Turn the adjuster on the control cable in the di-
rection of the arrow (
cable no longer sags (is slightly tensioned). Hold
the cable while tightening so that it does not
twist.
3. Tighten the lock nut(
4. Check the adjustment by starting the engine and
engaging the wheel drive.
5. If the wheel drive still does not engage and di-
sengage properly, have the machine repaired by
a qualified workshop.
Maintaining the auger drive
Adjusting the control cable
If the auger drive no longer engages when the engine
is running, the control cable must be adjusted.
Caution!
▪ Switch off the engine before adjusting the
control cable.
▪ If the auger drive mechanism cannot be
disengaged, switch off the engine. Do not
attempt repair; contact a qualified workshop.
1. Loosen lock nut (
2. Turn the adjuster on the control cable in the di-
rection of the arrow (
cable no longer sags (is slightly tensioned). Hold
the cable while tightening so that it does not
twist.
3. Tighten the lock nut(
2-1).
2-2) until the control
2-1) firmly.
2-1).
2-2) until the control
2-1) firmly.
GB
33