Troubleshooting; Eu Declaration Of Conformity - Scheppach 5906301901 Originalbetriebsanleitung

16 Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your product failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Product does not run.
Product works with interruptions. Internal loose contact.
The product is overheated.
Dust escapes from the product.

17 EU Declaration of Conformity

Translation of the original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the product
described here complies with the applicable directives
and standards.
Brand:
Art. designation:
Item no.
EU directives:
2014/30/EU, 2011/65/EU*, 2014/35/EU,
* The object of the declaration described above fulfils the
regulations of the directive 2011/65/EU of the European
Parliament and Council from 8th June 2011, on the re-
striction of the use of certain hazardous substances in
electrical and electronic equipment.
22 | GB
Possible cause
Product switched off. On/off switch
switched off.
Damaged mains connection cable.
On/off switch defective.
Engine defective.
Faulty power supply.
On/off switch defective.
Container not closed.
The airway is blocked.
The air filter is clogged.
The dust bag is full.
The container cover has not been in-
stalled correctly.
SCHEPPACH
Chip extraction system -
HD2P
5906301901
www.scheppach.com
Remedy
Switch the product on with the On/Off switch.
Switch the product off and disconnect from the
mains. Check for mains connection cable for
damage.
If necessary, have the mains connection cable
replaced by an authorised specialist.
Please contact our service department.
Check the electrical system for compliance with
the specifications on the type plate.
Please contact our service department.
Close the container.
Check the following parts for blockages and re-
move the blockages:
• Air filter
• Vacuum hose
• Dust bag
Clean the air filter.
Empty the dust bag.
Attach the container cover correctly.
Applied standards:
EN 60335-2-2:2010+A11:2012+A1:2013
EN 60335-1:2012+A11:2014+A13:2017+A1:2019+
A14:2019+A2:2019+A15:2021
EN 62233:2008
EN IEC 55014-1:2021
EN IEC 55014-2:2021
EN IEC 61000-3-2:2019+A1:2021
EN 61000-3-3:2013+A1:2019
Documentation authorised representative:
Georg Kohler
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 29.05.2026
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management