Trouble Shooting; Fault Correction - Parkside Pksa 20-Li B2 Originalbetriebsanleitung

GB CY

Trouble shooting

Problem
Device does not
start
Chain does not turn
and warning tone
sounds
Inferior cutting per-
formance
Saw runs with dif-
ficulty, chain comes
off
Chain becomes hot,
smoke development
during sawing, dis-
coloration of the rail
54
Possible cause
Battery ( 16) empty or not
inserted
Defective On/Off switch
( 2)
Defective motor
Chain brake blocks saw chain
( 7)
Incorrectly mounted saw chain
( 7)
Saw chain ( 7) blunt
Chain tension insufficient
Chain tension insufficient
Too little chain oil

Fault correction

Check the charge level, and have
repairs carried out by a qualified
electrician, if necessary.
Repair by customer service
Repair by customer service
Check chain brake.
Possibly release chain brake
Mount saw chain correctly
Sharpen cutting teeth or place on
new chain
Check chain tension
Check chain tension
Check oil level and, where appro-
priate, refill with chain oil,
check oil automatic system and,
where appropriate, clean oil
outflow duct or have repaired by
customer service