Permitted Use; Electrical Warnings - IKEA MATÄLSKARE Handbuch

ENGLISH
door with caution: allowing hot air or steam
to exit gradually before accessing the cavity
- risk of burns. Do not obstruct hot air vents
at the front of the oven - risk of fire.
Exercise caution when the oven door
is in the open or down position, to avoid
hitting the door.

PERMITTED USE

CAUTION: the appliance is
not intended to be operated by
means of an external switching
device, such as a timer, or
separate remote controlled
system.
This appliance is intended
to be used in household and
similar applications such as: staff
kitchen areas in shops, offices
and other working environments;
farm houses; by clients in hotels,
motels, bed & breakfast and
other residential environments.
Do not install the appliance
behind a decorative door - risk
of fire.
This appliance is not for professional
use. Do not use the appliance outdoors.
No other use is permitted (e.g. heating
rooms).
Do not store explosive or flammable
substances (e.g. gasoline or aerosol cans)
inside or near the appliance - risk of fire.
INSTALLATION
INSTALLATIONThe appliance must
be handled and installed by two or more
persons - risk of injury. Use protective gloves
to unpack and install - risk of cuts.
Installation, including water supply
(if any) and electrical connections, and
repairs must be carried out by a qualified
technician. Do not repair or replace any
part of the appliance unless specifically
stated in the user manual. Keep children
away from the installation site. After
unpacking the appliance, make sure that it
has not been damaged during transport.
In the event of problems, contact the
dealer or your nearest After-sales Service.
Once installed, packaging waste (plastic,
styrofoam parts etc.) must be stored out
of reach of children - risk of suffocation.
The appliance must be disconnected from
the power supply before any installation
operation - risk of electrical shock. During
installation, make sure the appliance does
not damage the power cable - risk of fire or
electrical shock. Only activate the appliance
when the installation has been completed.
Carry out all cabinet cutting works
before fitting the appliance in the furniture
and remove all wood chips and sawdust.
Do not obstruct the minimum gap between
the worktop and the upper edge of the oven
- risk of burn.
Do not remove the oven from its polystyrene
foam base until the time of installation.
After installation, the bottom
of the appliance must no longer
be accessible - risk of burn.

ELECTRICAL WARNINGS

The rating plate is on the front
edge of the oven (visible when
the door is open).
It must be possible to
5