Startup / Operation - BOMANN DTR 353 Bedienungsanleitung, Garantie

• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Electrical connection Electrical connection Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
Make sure that the voltage supply matches the
•
specifications on the rating label before
connecting.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Assembling the door handle Assembling the door handle Assembling the door handle Assembling the door handle
Position the handle and fix it with
three screws on the door.
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION CAUTION: : : :
CAUTION CAUTION
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
electric electric electric
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
section "Settings".
Settings Settings Settings Settings
Setting [ 0 ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1–5 ] regulate the different values
of the internal temperature.
Setting 0 Setting 0
Setting 0 Setting 0
Off state
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
17
Put on the handle cover.
Attach the cover with a screw.

Startup / Operation

Startup / Operation
Startup / Operation Startup / Operation
Setting 1 Setting 1
Setting 1 Setting 1
Lowest setting
(warmest inside
temperature)
Setting 5 Setting 5
Setting 5 Setting 5
Highest setting
(coldest inside
temperature)