Connections, Operating And Display Elements; Operation - Cameo OCTAFLY XS Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

6
1
POWER IN
IEC mains socket with built-in fuse holder. A suitable power cable is included. IMPORTANT: Replace the fuse only with a fuse of the same type
and of the same value according to the stamp on the device! In the event of repeated fuse failure, please contact an authorised service centre.
2
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
3
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
4
LED DISPLAY
The four-digit LED display shows the operating mode and other system information.
5
CONTROL BUTTONS
MODE: Selection of the main menu items. Move up one level in the menu structure.
ENTER: Confirm programme selection and value changes.
UP and DOWN: Selection of operation mode , system settings and programmes, e.g. changing of programme speed and DMX address.
6
MIC
Microphone for music-control mode

OPERATION

A few seconds after connecting to the mains, the spotlight is ready for operation and the previously selected operating mode is activated.
CONFIGURE DMX START ADDRESS
Press the MODE button repeatedly until "Addr" appears in the display. Now press ENTER and configure the DMX start address using the UP
and DOWN buttons as required (A001 - A512). Confirm your entry with ENTER. Synchronous control of several lamps of the same model
with a DMX controller (e.g. DMX console) can be achieved by configuring the lights with the same DMX starting address and the same DMX
mode setting and with the help of DMX cables.
-> ENTER -> UP/DOWN
DMX MODE SETTING
Press the MODE button repeatedly until "ModE" appears in the display. Now press ENTER twice and select the desired DMX mode by using
the UP and DOWN buttons as required (04Ch, 10Ch, 17Ch). Confirm your entry with ENTER. Tables with the channel assignment of the
different DMX modes can be found in these instructions under DMX CONTROL. If there is no DMX signal to the device, the characters in the
display will flash. If there is a DMX signal, the display will stop flashing.
-> ENTER ->
4
5
-
-> ENTER -> UP/DOWN
2
3
-> ENTER
<- MODE
/ /
1
-> ENTER
/
<- MODE
5