Safety Systems; Start Lock-Out; Overload Protection; Overview - Bosch MUM52 Series Gebrauchsanleitung

en
Safety systems

Safety systems

Start lock-out

See "Operating positions" table.
The appliance can be switched on in
pos. 1 and 3 only:
■ when the bowl (11) has been inserted and
turned until it locks into place
and
■ the blender drive cover has been
attached (8).
Restart lock-out
If the power is interrupted, the appliance
remains switched on but the motor does
not start running again when the power
is restored. To switch the appliance on
again, turn the rotary switch to P, then
switch on.

Overload protection

If the motor switches itself off while the
appliance is being used, the overload
protection feature has been activated. A
possible cause may be that too much food
was processed at one time.
If a safety system is activated, see
"Troubleshooting".
The operating instructions describe several
models, see also overview of models
(Fig. M). The appliance requires no
maintenance.
20

Overview

Please fold out the illustrated pages.
Fig. A:
Base unit
1 Release button
2 Swivel arm
"Easy Armlift" function to support the
upward movement of the arm (see
"Work positions").
3 Rotary switch
When the appliance has been switched
off (position P), the appliance runs
automatically to the optimum position for
changing the tools.
MUM52..:
P = Stop
M = Instantaneous switching at
maximum speed, hold switch for
required blending duration.
Settings 1-4, Operating speed:
1 = low speed – slow,
4 = high speed – fast.
MUM54../MUM55../MUM56../MUM58..:
P = Stop
M = Instantaneous switching at
maximum speed, hold switch for
required blending duration.
Settings 1-7, Operating speed:
1 = low speed – slow,
7 = high speed – fast.
4 On/Off display
(MUM54../55../56../58..)
Is lit while the appliance is operating
(rotary switch on M or 1-7). Flashes if
the appliance has been operated incor-
rectly, the electronic fuse has tripped or
the appliance is defective – see section
"Troubleshooting".
5 Drive cover
To remove the drive cover, press on the
rear area and remove cover.
6 Drive for
– Continuous-feed shredder and
– Citrus press (optional accessory*).
When not in use, attach the drive cover.
7 Drive for tools (stirrer, whisk, kneading
hook) and mincer (optional accessory*)
8 Blender drive cover