Bevel Cutting; External Dust Extraction; Attaching And Removing The Protective Cover; Attaching And Removing The Splinter Guard - Parkside Pstda 20-Li C3 Originalbetriebsanleitung

GB MT
4. Make a test cut, check the cutting width
and correct the position of the parallel
guide (28) if necessary.

Bevel cutting

Notes
• You can set the following cutting angles:
−45°; −22.5°; 0°; 15°; 30°; 45°
Tools required
• Hex key (27)
Procedure (Fig. D)
1. Switch off the device and remove the
battery. Make sure that all moving parts
have come to a complete stop.
2. Remove the splinter guard (25).
3. Loosen the hexagon socket screws (11)
with the hex key (27).
4. Pull the footplate (12) backwards slightly.
5. Adjust the footplate (12) to the desired
position.
6. Press the footplate (12) forwards into one
of the notches.
7. Tighten the hexagon socket screws (11)
with the hex key (27).

External dust extraction

Requirements
• The protective cover (21) is fitted.
Connecting external dust extraction
1. Disable the dust blower function (10).
2. Connect a suitable dust extraction (not
included) to the suction nozzle (6).
3. If the external dust extraction does not fit,
use the additional reducer piece (7).
Removing external dust extraction
1. Remove the dust extraction from the suc-
tion nozzle (6) or reducer piece (7).
2. Remove the reducer piece (7).
Attaching and removing the
protective cover
Attaching the protective cover
1. Press the two holders on the protective
cover (21) into the recesses on the tool
housing.
The protective cover clicks into place.
You can fold the fitted protective cover up by
65°.
Removing the protective cover
1. Carefully press the two holders on the
protective cover (21) apart.
26
2. Pull the protective cover to the front.
Attaching and removing the
splinter guard
Attaching the splinter guard
1. Press the splinter guard (25) into the re-
cess in the slide shoe (24).
Removing the splinter guard
1. Press the splinter guard (25) out of the re-
cess in the slide shoe (24).

Checking the battery charge level

LEDs
red, orange, green
red, orange
red
1. Press the button (31) next to the charge
level indicator button (30) on the battery
(4).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (4) when only the red
LED on the charge level indicator (30) is
illuminated.

Charging the battery

See also the charger instruction manual.
Notes
• If warm, allow the battery to cool before
charging.
• Do not expose the battery to direct sun-
light for long periods and do not place it
on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (4) from the device.
2. Push the battery (4) into the charging slot
of the battery charger (29).
3. Connect the battery charger (29) to a
power outlet.
4. After charging, disconnect the battery
charger (29) from the mains.
5. Pull the battery (4) out of the battery
charger (29).
Meaning
Battery charged
Battery partially
charged
Battery needs to be
charged