Attaching And Removing The Slide Shoe; Attaching And Removing The Saw Blade; Using The Parallel Guide - Parkside Pstda 20-Li C3 Originalbetriebsanleitung

• Switch lock (1)
• Locks the on/off switch against unin-
tentional operation.
• Unlocking: Press
• On/Off switch (2)
• Switching on: Press
• Switching off: Release
• Pendulum stroke switch (13)
Set pendulum movement of the saw
blade in 4 positions:
• 0 - no pendulum motion
• 1 - small pendulum motion
• 2 - medium pendulum motion
• 3 - large pendulum motion
• Switch (dust blower function) (10)
Blower function for chip-free cutting line
⭠
disable
Attaching and removing the slide
shoe
When working on scratch-sensitive work-
pieces, working with the slide shoe (9) is re-
commended.
Assembling the slide shoe (Fig. A)
1. Place the slide shoe (9) on the front of the
footplate (12).
2. Press the notches (8) on the back of the
slide shoe over the footplate (12).
Disassembling the slide shoe (Fig. A)
1. Press the slide shoe (9) on the notches
(8) away from the footplate (12).
2. Pull the slide shoe (9) forward, away from
the footplate (12) and off.
Attaching and removing the saw
blade
CAUTION! Risk of injury when
touching the saw blade. Wear pro-
tective gloves when handling the
saw blade.
Requirements
• The saw blade has a T-shank mount
(single lug shank) like the supplied saw
blades (16/18/17).
• The saw blade is suitable for the material
• The chuck is free of splinters or other ma-
• The saw blade has maximum thickness
Installing the saw blade (Fig. B)
1. Turn the release of the chuck (23) as
2. Place the saw blade (16/18/17) into the
3. Release the release of the chuck (23) los.
4. Make sure that the saw blade (16/18/17)
Removing the saw blade (Fig. B)
Hold the device in a way that no persons in
⭢
the vicinity are injured by the ejected saw
enable
blade.
1. Hold the saw blade (16/18/17) firmly.
2. Turn the release of the chuck (23) as far
3. Release the release of the chuck (23) los.

Using the parallel guide

The parallel guide can be fitted on both sides
of the tool.
Fitting the parallel guide (Fig. C)
1. Loosen the retaining screws (20) if neces-
2. Push the parallel guide (28) into the hold-
3. Retighten the retaining screws (20).
Removing the parallel guide (Fig. C)
1. Loosen the retaining screws (20).
2. Pull the parallel guide (28) out of the
Adjusting the parallel guide (Fig. C)
1. Loosen the retaining screws (20).
2. Set the scale on the parallel guide (28)
3. Retighten the retaining screws (20).
used.
terial residue.
of: ≤1.5 mm
far as possible. Keep the release of the
chuck fixed in this position.
chuck (14).When inserting the saw blade,
make sure that the back of the saw blade
is in the notch of the guide roller (15).
is attached correctly and the teeth are
pointing in the cutting direction.
as possible.
The saw blade (16/18/17) is ejected.
If the saw blade is not ejected: Hold the
release of the chuck and pull the saw
blade from the chuck.
sary.
ers (19).
holders (19).
so that you can read the desired cutting
width on the footplate (12) marking.
GB MT
25