Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
* Hold or attach the thermocouple(s) to the measurement location.
The temperature reading appears in the primary display.
* Press
to toggle between showing the T1, T2, T3,T1-T2,T1-
T3and T2-T3 readings in the primary or secondary display.
Notes
The display shows "- - - -" when a thermocouple is not connected.
The display shows OL (overload) when the temperature being
measured is outside the thermocouple's valid range.
8.12. Holding the Displayed Readings
* Press
to freeze the readings on the display .The display shows
HOLD.
* Press
to toggle showing the T1, T2, T3,T1-T2,T1-T3,or T2-T3
readings in the primary or secondary display.
* Press
again to turn off the HOLD function.
8.13. Viewing the MIN, MAX, and AVG Readings
* Press
to step through the maximum (MAX), minimum (MIN), or
the average (AVG) readings. The elapsed time since entering MIN
MAX mode, or the time at which the minimum or maximum occurred
appears on the display.
* Press
button for 3 seconds to exit MIN MAX mode.
-29-
Werbung
Inhaltsverzeichnis
