Function Check; Troubleshooting - Seca 645 Bedienungsanleitung

8

FUNCTION CHECK

9

TROUBLESHOOTING

Fault
No weight is displayed with a
load on the scale.
is displayed.
is displayed.
bAtt
0.0 (verified models)/ 0.00
(non-verified models) is not
displayed before weighing
takes place.
is displayed before
- - - - -
weighing takes place.
The weight display flashes.
► Perform a function check before each use.
A complete function check includes:
• A visual inspection for mechanical damage
• A test of the alignment of the device
• A visual and function check of the display elements
• A function check of all the controls shown in the section entitled "Overview"
• A function check of the optional accessories
If you find faults or deviations during the function check, first try to remedy the fault with
the aid of the "Troubleshooting" section in this document.
CAUTION!
Personal injury
If you find faults or deviations during the function check which you are unable to
remedy with the aid of the "Troubleshooting" section in this document, you must
not use the device.
► Have the device repaired by seca Service or an authorized service partner.
► Follow the section entitled "Servicing" in this document.
NOTICE!
Malfunction
If the device is equipped with the optional
and is connected to the
symbols which are not described here may occur.
► Follow the system instructions for use for
If faults occur when operating the device, first attempt to remedy them yourself using
the following table. If the fault persists, contact seca Service.
Cause
The device has no power supply.
Battery pack capacity is decreasing
Battery pack is discharged
A load was already on the device before
it was switched on.
A load was already on the device before
it was switched on.
Consistent weight value not yet de-
tected.
seca 452
software, error messages and error
seca connect 103
seca 103/452
• Switch on device.
• Connect the power supply unit.
Recharge the battery pack soon
Charge battery pack
• Remove the load from the device.
• Switch off the device, then switch it back
on again.
• Remove the load from the device.
• Switch off the device, then switch it back
on again.
• One of the following functions is active:
,
Hold Autohold
vice has detected a consistent weight
value. The display stops flashing.
• Take the load off the device, wait until
/ is displayed and measure again.
0.0 0.00
English
external interface module
.
Remedy
, . Wait until the de-
Tare
Function check • 63