Mounting the saw chain and blade
WARNING!
►
Wear protective gloves! There is a risk of
injury from the sharp cutting teeth!
♦
Remove the two screws
sprocket cover.
♦
Place the sawing chain
groove.
♦
To install, hold the blade
of approx. 45 degrees upward, and guide the
sawing chain
around the chain wheel
♦
Lay the guide rail
while inserting the chain tensioner pin
blade hole
.
♦
Refit the sprocket cover and finger-tighten the
two screws.
NOTE
►
Make sure that the nose of the cover is inserted
into the designated notch on the device.
♦
Now you can tighten the saw chain (see section
Tightening and checking the saw chain).
♦
Then tighten the screws of the sprocket cover.
Tightening and checking the saw chain
WARNING!
►
Wear protective gloves! There is a risk of
injury from the sharp cutting teeth!
♦
Unscrew the two screws
sprocket cover
.
♦
Using the assembly tool
tensioner screw
in a clockwise direction to
increase the tension.
♦
The saw chain
must lie against the underside
of the blade. Check whether the saw chain can
be drawn by hand over the blade
♦
Replace sprocket cover
the two screws
.
NOTE
►
Make sure that the nose of the cover is inserted
into the designated notch on the device.
■
10
│
GB
and remove the
into the blade
tilted at an angle
over the blade guide
in the
and remove the
, turn the chain-
.
and finger-tighten
NOTE
►
A new saw chain stretches and must be
tightened more regularly.
Lubricating the chain
♦
Remove the oil filler cap
♦
Fill the oil tank with approx. 65 ml of organic
chain oil
.
WARNING!
►
Never work without chain lubrication!
.
If the saw chain runs dry, the cutting equip-
ment may become irreparably damaged
within a short time. Always check chain
lubrication and oil level in the tank before
starting work.
NOTE
►
Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
►
While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.
Sharpening the saw chain
NOTE
►
You will find detailed information on
sharpening in the sharpening set, e.g. from
Oregon.
►
Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
►
If you have any doubts about implementing
the work, the saw chain should be replaced.
.
FAHE 18 B2