Sentiotec WC4-B-11 Installations- Und Gebrauchsanleitung Seite 6

Instructions for installation and use p. 6/38
2. Important information for your safety
The wave.com4 11 kW sauna controller has been manufactured
according to the applicable safety regulations. However, hazards
may arise during use. You should therefore adhere to the following
safety information and the specific warnings in the installation and
operating instructions. Also observe the safety information for the
devices connected.
2.1. Intended use
The wave.com4 11 kW sauna controller is designed solely for oper-
ating and controlling the functions described in the technical data.
The sauna controller may only be used for operating and controlling
three heating circuits with a maximum output of 3.7 kW per heating
circuit.
When using the optional wave.com4 expansion board (WC4-H-PCB),
the maximum evaporator output is 3.0 kW.
According to EN 60335-2-53 sauna remote control units may only be
used to regulate and control a sauna heater that passes the cover test
according to paragraph 19.101. Alternatively, an appropriate safety
measure (e.g.: safety shutdown, door contact...) must be installed.
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, severe injuries or death.
The warranty is void if the device is not used as intended.