Fronius Power Control Card Bedienungsanleitung Seite 39

- Ripple control signal receivers with non-isolated contacts must not be connected to
the Fronius Power Control Card.
- In addition to the Fronius Power Control Card, no Fronius Power Control Boxes are
permitted in the network.
- Only one Fronius Power Control Card may be installed in each inverter.
- The Fronius Power Control Card can be used with the following Fronius inverters:
- Fronius IG Plus
- Fronius IG Plus V
- Fronius CL
- Fronius IG TL
- Fronius Agilo
NOTE! The Fronius Power Control Card can only be used with the Fronius IG TL
and Fronius Agilo inverters in combination with a Fronius inverter that has a slot
for an option card. The Fronius Power Control Card is installed in the inverter with
the option card slot.
- If several inverters are networked together, the Fronius Power Control Card may only
be installed in one inverter. The other inverters require a Fronius Com Card or a Com
Card function to execute the Fronius Power Control Card control commands.
- In order for the Fronius Power Control Card to function correctly, the Fronius Solar Net
protocol (not the IFP protocol) must be active in the inverter.
The Fronius Solar Net protocol is the default factory option.
- All the above inverters (serial number 20220769 and higher) are compatible with the
Fronius Power Control Card.
- The inverter requires the following versions of electronic components to drive the Fro-
nius Power Control Card:
In the inverter
Fronius IG Plus
Fronius IG Plus V
Fronius CL
Fronius IG Plus
Fronius IG Plus V
Fronius CL
Fronius IG TL
Fronius Agilo
* For proper control in line with CEI 0-21
CEI 0-21-compliant control is not possible with the Fronius IG TL and Fronius Agilo invert-
ers.
NOTE! When installing the Fronius Power Control Card in the inverter, follow the
inverter operating instructions, especially the safety rules and the section entitled
"Inserting option cards".
Electronic component
IG BRAIN
PINCI
PINCI 2 (hardware version 2.0A)
PINCI rack (hardware version 1.0A)
CERBO
TL-5 KW
MECERCAP
power stage set
From software ver-
sion
V. 4.28.20
V. 1.4.32
V. 3.07.34 *
V. 3.07.34 *
V. 1.1.0.0
V. 1.1.0.0
since the start
since the start
37