Respekta CH 22078 IX B Bedienungsanleitung Seite 23

4. Drill the holes
suspension device with the screws
and dowels.
5. Hang the hood on the fixed
suspension device.
6. Install the flat bar on the bottom chimney first, then on the wall. You can carry
out this step provisionally to mark the drillings of the wall mounting and drill
the relevant holes.
Chimney
7. Place the top and bottom chimney on the hood and fix the bottom one on it
(look at the drawing connect chimney to hood).
8. Fix the chimney-installation bracket below the ceiling on the wall using the
screws and dowels.
Screw chimney ↔
bracket
9. Lay the exhaust hose to the wall
outlet. Fix the exhaust hose with the
cable tie (1) on the wall-outlet.
10. Fix the top chimney on the installation bracket ( look also on step 8).
11. Insert the grease filters and connect the appliance to the mains
If the socket is covered by the chimney, you must plug in the appliance at an
3
and fix the
Wall
23
Chimney
Screw chimney
bracket
3
.
↔