Respekta CH 22078 IX B Bedienungsanleitung Seite 22

Screws for wall mounting
1 Installation bracket 2 pcs. 4*40
2 Flat bar 2 pcs. 4*30
3 Suspension device 3 pcs. 4*40
Installation steps
1. Install the 2 semi-circular valve flaps (a/b) into the air-outlet-opening of the
appliance. Insert the axles of the valve flaps into the relevant openings (1b) by
bending them carefully (1a). Both valve flaps shall open outwards (2).
2. Now connect the exhaust hose to the air-outlet
opening of the hood. Put the widened end of the
exhaust hose over the air-outlet. Start at the back
of the air-outlet then proceed from inside the
exhaust hose by installing it (use your thumbs)
on the air-outlet.
3. Place the suspension device on the wall. Select the position relevant to the
dimensions of the entire appliance. Mark the drillings with a pencil before.
Fixing the chimney to →
4 Installation bracket 2 pcs. 4*8
5 Flat bar 2 pcs. 4*8
6 Hood 2 pcs. 4*8
22