Respekta CH 22078 IX B Bedienungsanleitung Seite 20

16. Always supervise children so they will not play with the appliance.
1. Accessible parts of the hood may become hot while cooking.
2. Carry out the installation of the appliance with at least two persons. Risk of
damage. RISK OF INJURY!
1. The appliance must be transported and installed by at least two persons.
2. Unpack the parts of the chimney very carefully; otherwise you will damage the
chimney
3. Remove the complete packaging materials before initial operation. The
appliance may be equipped with a transportation lock. Remove the
transportation lock completely. When removing be very careful. Do not use any
aggressive detergents to remove residues of the transportation lock.
4. Clean and maintain the appliance regularly to enable its proper operation and
optimal performance.
5. Take the enclosed parts from the packaging and its polystyrene-
components.
6. Check that the power cord and the appliance are not damaged before electrical
connection.
2. Installation
WARNING! Do not lead the exhaust air into a chimney which is
1.
used for extracting exhaust air of appliances operated by gas or other
combustibles.
2. For extracting the exhaust air always observe the current legal regulations.
3. The diameter of the exhaust hose must meet the diameter of the connecting
ring.
4. If your appliance is equipped with a carbon filter, remove the carbon filter
before you operate the appliance in the extraction mode. The carbon filter
should be used in the recirculating mode only.
5. The exhaust duct should be as short and straight as possible. The diameter of
the exhaust hose should be at least 120/150 mm (look at chapter T
D ). Otherwise you have to expect increased noise and decreased
ATA
performance of your appliance.
6. The proper maximum bending angle outwards is 120
7. Use smooth tubes or flexible, non-inflammable exhaust hoses only.
CAUTION!
NOTICE!
20
ECHNICAL
0
.