Panasonic EY75A7 Bedienungsanleitung Seite 11

Hard
• Jobs requiring high
0 – 2500 r.p.m.
and
0 – 3100 i.p.m.
Medium • Jobs requiring decent
0 – 1450 r.p.m.
and
0 – 2900 i.p.m.
Soft • Jobs requiring limited
• Jobs requiring minimal
0 – 950 r.p.m.
and
0 – 1900 i.p.m.
Self-drilling • Jobs requiring flush
screw
0 – 2500 r.p.m.
and
0 – 1200 i.p.m.
* i.p.m. = Impact per minute.
EY75A7_EU.indb 11
torque where there is
no possibility of break-
ing screw or chipping
screw head.
* Fastening larger
size bolt (M8 or
larger)
* Fastening long
wood screw
torque with minimizing
the possibility of break-
ing screw, chipping
screw head, or break-
ing bit.
* Fastening smaller
diameter bolt (such
as M6)
torque with eliminating
the possibility of break-
ing screw, chipping
screw head, or break-
ing bit.
damage of finished
exterior surface.
* Fastening smaller
diameter bolt (M6 or
smaller)
* Fastening into
plastic
* Installing drywall
finish of self-drilling
screw.
(dia. 4 mm × 15 mm or
smaller)
(Automatic mode
change starting from
Hard mode to slower
r.p.m. before flush
finish)
Avoid repeatedly depressing the switch
when the bolts and screws are securely
fastened.
Not doing so may cause a delay in rotation
starting, or the Impact Power mode
display to flash and prevent rotation from
starting for circuit protection.
LED Light
Press the light button and set illumination
condition.
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates when depressing the
trigger switch.
Turns off when the trigger is
released.
Off
The light illuminates with very low current,
and it does not adversely affect the perfor-
mance or its battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
- 11 -
EN
2015/07/16 11:29:19