Herunterladen Diese Seite drucken

Pentacon Praktica PLC 2 Bedienungsanleitung Seite 26

Werbung

Auswechseln der Stromquelle
Als Stromquelle für die Belichtungsautomatik wird ein
e
Batterie
für Fotoapparate mit einer Nennspannung von 4,5 V
verwendet.
Batterieraum (33) durch Anheben des Plastedeckels am Griffstück
öffnen. Beim Einsetzen der Batterie ist auf richtige Polung zu
achten. Batterie mit Pluspol gegen den federnden Kontakt (eben-
falls
+
gekennzeichnet) drücken und gleichzeitig in den Batterie-
raum hineinkippen.
Batterieraumdeckel gegenüber der Griffseite am Batterieraum an-
setzen und an der Griffseite niederdrücken, bis er einra stet.
Lebensdauer der Stromquelle ca
.
2
Jahre.
Verbrauchtes Element nicht aufladen oder ins Feuer werfen!
Explosionsgefahr!
50
Changing the battery
The automatic exposure
system
is powered by a camera battery
of 4.5 V rated voltage. Open the battery compartment (33) by Iifting
the plastic Iid at the provided recess
.
Insert the new battery and
press the plus pole towards the resilient contact also marked w ith
the plus sign, and tilt the battery in.
Insert
the battery compartment Iid opposite to the recess
side
and
press down at the latter till the Iid Iacks.
This battery change will not cause you much trouble; it is only
necessary at intervals of about 2 years
.
Do not try and recharge used batteries and do not throw them into
the Iire- they may blow up
.
Remplacement de Ia source de courant
C'est une pile pour appareils photographiques,
a
4,5 volts de
tension nominale, qu'on utilise comme source de courant pour le
systeme
d'exposition automatique. Ouvrir le polier
a
pile (33) en
soulevant Je couvercle en matiere plastique (pourvu d'l.ln onglet).
Lors le l'introduction de Ia
pile,
il faut veiller a ce que Ia polari-
sation soit correcte
.
Appliquer le pole positif de Ia pile contre le
contact
a
ressort (egalement pourvu du signe
«+»)
et, en meme
temps, faire basculer Ia pile dans ledit polier. Appliquer le cöte
du couvercle qui est oppose a celui qui porte ledit onglet contre le
bord du polier a pile, et enfoncer Je couvercle sur Je cöte ou
se
trouve l'onglet, jusqu'a ce qu'il prenne dans Je cran d'immobili-
sation.
La longevite de Ia source de courant est de deux ans environ
.
Ne pasessayerde recharger une pile morte, ni Ia jeterdans le feu
.
Danger d'explosion!
51

Werbung

loading