Troubleshooting; Causes Of Malfunction And Fault Rectifi Cation; Possible Cause - Silvercrest SLE 320 A1 Bedienungsanleitung

GB

Troubleshooting

Causes of malfunction and fault rectifi cation
Fault
The appliance
will not switch
on.
The appliance
is producing
no or limited
condensate.
Water is
pooling on the
fl oor.
The air ejected
is warm.
The error code
E 1 is fl ashing
on the display.
The error code
E 2 is fl ashing
on the display.
20
This section contains important information on fault identifi cation and rectifi cation.
The following Table will help to identify and rectify minor faults:

Possible cause

The mains plug is not plugged in.
The mains power socket is not
supplying power.
Safety stop due to the water
tank being missing or having
5
been inserted incorrectly.
The water tank 5
The air inlet or air outlet aperture
is soiled or obstructed.
The room's windows and doors
are open.
Is the appliance running in the
AIR CLEAN programme? Dehu-
midifi cation is not taking place.
The appliance was overly agitated
during positioning. There is re-
sidual water in the appliance.
Heat exchange process
Coil temperature error
The humidity sensor is defective.
NOTE
► If you are unable to resolve the problem applying any of the aforementioned
methods, please contact the Customer Service department
(see the chapter Service).
Rectifi cation
Insert the mains plug into the mains
power socket.
Check the house's mains fuse.
Insert the water tank
Empty the water tank
is full.
it.
Ensure that the air inlet and air outlet
apertures are clean and free of
obstructions.
Close the windows and doors.
Select a diff erent programme, such as
AUTOMATIC MODE.
This is a normal feature of the ap-
pliance. When re-positioning the
appliance, ensure that it is not overly
agitated.
This is a normal feature of the appli-
ance.
Contact the Customer Service depart-
ment.
Contact the Customer Service depart-
ment.
5 correctly.
5 and re-insert
SLE 320 A1