Operation; Control Board; Navigate Through The Menu - EuroLite HST-150 Bedienungsanleitung

OPERATION

After you connected the device to the mains, the EUROLITE HST-150 starts running.
The LED display lights up and you can choose the desired mode via the buttons MENU, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in Stand Alone mode via LED display with
operating buttons or alternately in DMX-controlled mode via lighting controller.

Control Board

The control board offers several features, i.e. setting the DMX starting address, running a preset program or
selecting a DMX channel mode.
MENU UP DOWN ENTER

Navigate through the menu

Press MODE to navigate through the 6 points of the main menuof the HST-150.
Main menu Sub menu
Addr
ALL
rESt
FACt
MOdE
ConF
nSiG
CHnL
inFO
V101
diSP dMod
ModE DMSG
Note: The functions in gray are for the LED Space ball 35, which must be purchased separately.
Browse through the menu by pressing MENU. You can change
the selection by pressing UP or DOWN. Press ENTER in order
to confirm or to go to a sub-menu. You can leave every mode by
pressing MENU. The functions provided are listed in the
following sections.
Value Functions
001-512 Set DMX-Start address
Reset alle functions
SurE Strr
P234 Reset to default
7CH/8CH Set CH7 or CH Mode
All outputs can be deleted after 2 seconds (Crdt), or the
Crdt/HdLE
last DMX value can be saved before DMX is turned off
1rEd CH1 Red Dimmer
2Grn CH2 Green Dimmer
3bLU CH3 Blue Dimmer
4diM CH4 Master Dimmer
5FSH CH5 Strobe
6tiL CH6 Lifting
7SPd CH7 Lifting speed, not available in 7CH-Mode
8CtL CH8 Control. In 7CH Mode displayed as "7CtL".
Firmware Version
LED display always on (ALon), or automatically off after 5
ALon/dYoF
seconds (dYoF)
rECE Set DMX Mode
24/27 00085268, Version 1.0