EuroLite HST-150 Bedienungsanleitung Seite 21

ATTENTION: the HST-150 should not be used without the LED Spaceball 35.
The lifting cable located in the interior of the HST-150 The LED Space ball 35 must be fixed before the HST-
150 is taken into operation. The HST-150 must not be operated without load (LED Spaceball 35), since the
lifting cable could entangle inside and cause errors.
Step 1: Once the LED Space ball 35 is mounted, restart the HST-150 by setting the power switch to ON. The
HST-150 begins with resetting.
Blinks wenn data is
received
Schritt 2: Connect the HST-150 with a DMX controller.
Move the fader for 6CH to 20 to
check the DMX connection. If the
ball rolls smoothly, the connection
is fine.
Lights up as soon
as the device is
attached to the
mains.
Shows the DMX
address
After checking,
push the fader
for 6CH back
to 0.
The LED Space ball
35 on the lifting cable
should
smoothly.
21/27
move
00085268, Version 1.0