Stand-Alone Mode 1 Addr - Selection Dmx Start Address; Dmx-Controlled Operation - EuroLite HST-150 Bedienungsanleitung

STAND-ALONE MODE
1 Addr - selection DMX start address
In this menu item you can set the DMX start address.
• Adjust with UP and DOWN a value from 001-512.
2 rEST - functions and factory settings
With this menu item, functions and factory settings are reset.
3 ConF - DMX mode settings
Under MOdE You can adjust the desired DMX channel mode: CH7 - Lifting speed or CH8 - Control.
•
Under nSiG all outputs can be deleted after 2 seconds (Crdt), or the last DMX value can be saved
•
before the DMX is turned off (HDLE).
4 inFO - Manual DMX control
Under Chnl you can control the 8 DMX channels via the Control Board.
•
Under V101 you can see the firmware version.
•
5 diSP - adjust LED display
With this menu item, the LED display can be adjusted.
LED display always on (ALon), or automatically off after 5 seconds (dYoF)
•
6 ModE - DMX-controlled mode
In this menu item you can set the DMX mode.

DMX-controlled operation

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the HST-150 will respond to the controller.
Controlling:
After having addressed the HST-150, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the LED display lights up permanently then switches off automatically.
If there is no data received at the DMX-input, the LED display will blink.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
25/27 00085268, Version 1.0