Remove The Flow Regulator And Flow Limiter - Ecolab Smartpower Rtu Dispenser Bedienungsanleitung

Servicing and maintenance
7.2.7

Remove the flow regulator and flow limiter

Personnel:
Protective equipment:
Requirements:
n Angle valve for water supply closed.
n Front hatch open.
Product cylinder is removed.
n
on page 37
Fig. 19: Remove the flow regulator and flow limiter
1. Press the retaining rings onto the plug-in couplings
water pipe
2.
Remove the flow regulator
3. If necessary, press the retaining rings onto the plug-in couplings
the clean water pipe
ð The flow regulator and flow limiter are separated from each other.
4. If necessary, unscrew the T-piece
5. Pay particular attention to the following during installation:
n Push the clean water pipes into the plug-in couplings until you hear a click.
n If the flow regulator is replaced, have Ecolab Customer Service adjust the flow
rate of the unit.
MAN054127 Ver. 01-06.2024
n Service Personnel
Protective eyewear
n
Chemical resistant protective gloves
n
Ä Chapter 7.2.2 'Opening the front hatch' on page 36
Ä Chapter 7.2.3 'Remove the product cylinder'
1
3
3
7
4
4
5
6
2
3
4
.
4
and flow limiter
1
.
6
Ä 'Manufacturer' on page 11
Flow regulator
1
Flow limiter
2
Plug-in coupling
3
Clean water pipe
4
Plug-in coupling
5
Clean water pipe
6
T-piece
7
and disconnect the clean
3
together.
2
from the flow regulator.
7
44
and disconnect
5