Remove The Clean Water Valve - Ecolab Smartpower Rtu Dispenser Bedienungsanleitung

7.2.6

Remove the clean water valve

Personnel:
Protective equipment:
Requirements:
n Angle valve for water supply closed.
n Front hatch open.
Product cylinder is removed.
n
on page 37
n Water distributor removed.
nozzle' on page 39
2
1
4
Fig. 18: Remove the clean water valve
1. Unscrew the domestic water pipe (steel braid) at the clean water valve input.
2. Press the retaining rings onto the plug-in couplings
water pipe
3. Remove the screws
4. Remove the clean water valve
5. Pay particular attention to the following during installation:
n Push the clean water pipes into the plug-in couplings until you hear a click.
n Service Personnel
Protective eyewear
n
Chemical resistant protective gloves
n
Ä Chapter 7.2.2 'Opening the front hatch' on page 36
Ä Chapter 7.2.3 'Remove the product cylinder'
Ä Chapter 7.2.4 'Descale the water distributor and spray
1
4
3
2
.
1
.
3
4
Servicing and maintenance
Clean water pipe
1
Plug-in coupling
2
Screw
3
Clean water valve
4
2
3
and disconnect the clean
2
from the machine.
43 MAN054127 Ver. 01-06.2024