Check The Flow Rate - Ecolab Smartpower Rtu Dispenser Bedienungsanleitung

7.2.8

Check the flow rate

Personnel:
Protective equipment:
Requirements:
n Front hatch open.
n Product cylinder is removed.
on page 37
The water pressure of the fresh water supply is 3 bar ± 0.5 bar.
n
1. Cover the nozzle with a suitable container so that no water splashes out of the water
distributor.
2. Feed the product drain pipe into a suitable container with quantity markers.
3. Press the release button for one minute.
4. Check how much water was extracted:
n SMARTPOWER
n SMARTPOWER
n SMARTPOWER
5. If necessary, have the flow rate of the instrument adjusted by Ecolab Customer
Service.
n Service Personnel
Protective eyewear
n
Chemical resistant protective gloves
n
Ä Chapter 7.2.2 'Opening the front hatch' on page 36
Ä Chapter 7.2.3 'Remove the product cylinder'
Manual Dispenser RTU: 7.5 l/min ±1.5 l/min
TM
Presoak Dispenser RTU: 3 l/min ±1.5 l/min
TM
Pot&Pan Soak Dispenser RTU: 3 l/min ±1.5 l/min
TM
Ä 'Manufacturer' on page 11
Servicing and maintenance
45 MAN054127 Ver. 01-06.2024